Cisco SG220-26P Administration Guide

Administration: Discovery
Configuring LLDP
Cisco 220 Series Smart Switches Administration Guide Release 1.1.0.x 93
8
• Current Capabilities—MED capabilities enabled on the port.
• Device Class—LLDP MED endpoint device class.
• PoE Device Type—(Only applicable for PoE models) Port PoE type, for
example, powered.
• PoE Power Source—(Only applicable for PoE models) Port power source.
• PoE Power Priority—(Only applicable for PoE models) Port power priority.
• PoE Power Value—(Only applicable for PoE models) Port power value.
• Hardware Revision—Hardware version.
• Firmware Revision—Firmware version.
• Software Revision—Software version.
• Serial Number—Device serial number.
• Manufacturer Name—Device manufacturer name.
• Model Name—Device model name.
• Asset ID—Asset ID.
Location Information
• Civic—Street address.
• Coordinates—Map coordinates: latitude, longitude, and altitude.
• ECS ELIN—Emergency Call Service (ECS) Emergency Location
Identification Number (ELIN).
Network Policy Table
• Application Type—Network policy application type, for example, Voice.
• VLAN ID—VLAN ID for which the network policy is defined.
• VLAN Type—VLAN type for which the network policy is defined. The
possible field values are:
-
Tagged —Indicates the network policy is defined for tagged VLANs.
-
Untagged —Indicates the network policy is defined for untagged VLANs.
• User Priority—Network policy user priority.
• DSCP—Network policy DSCP.

Cisco SG220-26P Specifications

General

Model	SG220-26P
Ports	26
PoE Ports	24
Switching Capacity	52 Gbps
Forwarding Rate	38.69 Mpps
Layer	Layer 2
Power Supply	Internal
VLANs Supported	256
Management	Web-based GUI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Operating Humidity	10% to 90% non-condensing
Storage Humidity	5% to 95% non-condensing
Dimensions	440 x 44 x 257 mm
Weight	3.3 kg