EasyManuals Logo

Cisco TelePresence DX70 Reference Guide

Cisco TelePresence DX70
202 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #119 background imageLoading...
Page #119 background image
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
Copyright © 2017 Cisco Systems, Inc. All rights reserved. 119
Cisco TelePresence DX70 and DX80
API Reference Guide
xCommand Provisioning ExtensionMobility Login
Login command for the Extension Mobility service. You log in to the Extension Mobility service
with a user name (UserId) and pin code (Pin). The user name and pin code are set up in CUCM.
CUCM also supports multiple profiles for a user.
If you, for a user that has multiple profiles, submit a login command with only user name and
pin code, CUCM will send a list of available profiles back to the video system. Then the video
system will create corresponding ExtensionMobilityProfileSelection Profile events, so that a
new login command, which contains the Profile parameter in addition to the user name and pin
code, can be submitted.
Requires user role: ADMIN, USER
USAGE:
xCommand Provisioning ExtensionMobility Login UserId: "UserId" Pin: "Pin"
[Profile: "Profile"]
where
UserId
: String (1, 255)
A valid user name, as set up in CUCM.
Pin
: String (1, 255)
A valid pin code for the user, as set up in CUCM.
P rofile
: String (1, 255)
A valid profile for the user, as set up in CUCM. This parameter applies only if the user
has multiple profiles.
xCommand Provisioning ExtensionMobility Logout
This command will log you out of your Extension Mobility profile.
Requires user role: ADMIN, USER
USAGE:
xCommand Provisioning ExtensionMobility Logout
Proximity commands
xCommand Proximity Services Activate
Reactivate the Proximity services that were deactivated with xCommand Proximity Services
Deactivate.
Requires user role: ADMIN, USER
USAGE:
xCommand Proximity Services Activate
xCommand Proximity Services Deactivate
This command deactivates all proximity services on the endpoint. To reactivate proximity
services use the command xCommand Proximity Services Activate.
Requires user role: ADMIN, USER
USAGE:
xCommand Proximity Services Deactivate
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xCommand

Table of Contents

Other manuals for Cisco TelePresence DX70

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco TelePresence DX70 and is the answer not in the manual?

Cisco TelePresence DX70 Specifications

General IconGeneral
BrandCisco
ModelTelePresence DX70
CategoryConference System
LanguageEnglish

Related product manuals