Cisco TelePresence DX70 - Standby Commands; Xcommand Standby Activate; Xcommand Standby Deactivate; Xcommand Standby Halfwake

D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
Copyright © 2017 Cisco Systems, Inc. All rights reserved. 123
Cisco TelePresence DX70 and DX80
API Reference Guide
Standby commands
xCommand Standby Activate
Set the system in standby mode, which turns off the video outputs and put the camera into
sleep mode.
Requires user role: ADMIN, INTEGRATOR, USER
USAGE:
xCommand Standby Activate
xCommand Standby Deactivate
Bring the system out of standby mode.
Requires user role: ADMIN, INTEGRATOR, USER
USAGE:
xCommand Standby Deactivate
xCommand Standby Halfwake
Sets the system to "Halfwake" state. This state informs the user from the UI, to pick up a
remote or to tap the touch device to get started.
Requires user role: ADMIN, INTEGRATOR
USAGE:
xCommand Standby Halfwake
xCommand Standby ResetTimer
Set a temporary standby delay. If the system is in standby mode when the reset timer is set,
the system is brought out of standby mode. When left idle for the given delay the system goes
into standby mode. Setting the reset timer does not affect the Standby Delay in the Advanced
configuration menu (or by xConfiguration Standby Delay). Next time this delay is the valid
standby delay.
Requires user role: ADMIN, USER
USAGE:
xCommand Standby ResetTimer Delay: De lay
where
Delay : Integer (1..480)
Set the delay in minutes.
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xCommand