EasyManua.ls Logo

Cisco TelePresence DX70 - Dos and Donts

Cisco TelePresence DX70
202 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
Copyright © 2017 Cisco Systems, Inc. All rights reserved. 37
Cisco TelePresence DX70 and DX80
API Reference Guide
Dos and don’ts
Here are some best practices when programming the Cisco
series API.
DO use complete commands
You should always use complete commands when
programming, i.e. always use xConfiguration Video instead of
xconf vid. The shortcuts can be used for searches in the API
on the command line, but not for programming. The reason
for this is that you might end up with ambiguous code when
additional commands are added to the API.
DO NOT subscribe to unnecessary feedback
Subscribing to too much feedback may congest the control
application. Although the amount of feedback may seem fine
in the current version, the amount of feedback may grow in
future releases.
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus
About the API

Table of Contents

Other manuals for Cisco TelePresence DX70

Related product manuals