Cisco TelePresence DX70 - Xconfiguration Video Selfview Default Fullscreenmode; Xconfiguration Video Selfview Default Onmonitorrole; Xconfiguration Video Selfview Default Pipposition

D15363.05 Cisco TelePresence DX70 and DX80 API Reference Guide CE9.2, NOVEMBER 2017.
Copyright © 2017 Cisco Systems, Inc. All rights reserved. 88
Cisco TelePresence DX70 and DX80
API Reference Guide
xConfiguration Video Selfview Default FullscreenMode
Define if the main video source (self-view) shall be shown in full screen or as a small picture-
in-picture (PiP) after a call. The setting only takes effect when self-view is switched on (see the
Video Selfview Default Mode setting).
Requires user role: ADMIN, INTEGRATOR
Default value: Current
USAGE:
xConfiguration Video Selfview Default FullscreenMode: FullscreenMode
where
FullscreenMode : Off/Current/On
Off: self-view will be shown as a PiP.
Current: The size of the self-view picture will be kept unchanged when leaving a call, i.e.
if it was a PiP during the call, it remains a PiP after the call; if it was fullscreen during the
call, it remains fullscreen after the call.
On: The self-view picture will be shown in fullscreen.
xConfiguration Video Selfview Default OnMonitorRole
Define which monitor to display the main video source (self-view) on after a call. Note that this
video system has only one monitor, so this value is fixed and cannot be changed.
Requires user role: ADMIN, INTEGRATOR
Default value: First
USAGE:
xConfiguration Video Selfview Default On MonitorRole: OnMonitorRole
where
OnMonitorRole : First
First: The self-view picture will be shown on the integrated screen.
xConfiguration Video Selfview Default PIPPosition
Define the position on screen of the small self-view picture-in-picture (PiP) after a call. The
setting only takes effect when self-view is switched on (see the Video Selfview Default Mode
setting) and fullscreen view is switched off (see the Video Selfview Default FullscreenMode
setting).
Requires user role: ADMIN, INTEGRATOR
Default value: Current
USAGE:
xConfiguration Video Selfview Default PIPPosition: PIPPositi on
where
PIPPosition : Current/UpperLeft/UpperCenter/UpperRight/CenterLeft/CenterRight/
LowerLeft/LowerRight
Current: The position of the self-view PiP will be kept unchanged when leaving a call.
UpperLeft: The self-view PiP will appear in the upper left corner of the screen.
UpperCenter: The self-view PiP will appear in the upper center position.
UpperRight: The self-view PiP will appear in the upper right corner of the screen.
CenterLeft: The self-view PiP will appear in the center left position.
CentreRight: The self-view PiP will appear in the center right position.
LowerLeft: The self-view PiP will appear in the lower left corner of the screen.
LowerRight: The self-view PiP will appear in the lower right corner of the screen.
Introduction
About the API
xConfiguration
Appendices
xCommand
xSt atus

xConfiguration