2-68
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
define interface-range
For physical interfaces:
• module is always 0.
• the range is type 0/number - number (for example, gigabitethernet 0/1 - 2).
When you define a range, you must enter a space before the hyphen (-), for example:
gigabitethernet0/1 - 2
You can also enter multiple ranges. When you define multiple ranges, you must enter a space after the
first entry before the comma (,). The space after the comma is optional, for example:
fastethernet0/3, gigabitethernet0/1 - 2
fastethernet0/3 -4, gigabitethernet0/1 - 2
Examples This example shows how to create a multiple-interface macro:
Switch(config)# define interface-range macro1 fastethernet0/1 - 2, gigabitethernet0/1 - 2
Related Commands Command Description
interface range Executes a command on multiple ports at the same time.
show running-config Displays the current operating configuration, including defined
macros. For syntax information, select Cisco IOS Configuration
Fundamentals Command Reference, Release 12.2 > File Management
Commands > Configuration File Management Commands.
To Next Page
Loading...
Need help?
General