Cisco WS-C3560E-24PD-E User Manual

2-110
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
errdisable recovery
errdisable recovery
Use the errdisable recovery global configuration command to configure the recover mechanism
variables. Use the no form of this command to return to the default setting.
errdisable recovery {cause {all | arp-inspection | bpduguard | channel-misconfig |
dhcp-rate-limit | dtp-flap | gbic-invalid | l2ptguard | link-flap | loopback | pagp-flap |
psecure-violation | security-violation | udld | vmps} | {interval interval}
no errdisable recovery {cause {all | arp-inspection | bpduguard | channel-misconfig |
dhcp-rate-limit | dtp-flap | gbic-invalid | l2ptguard | link-flap | loopback | pagp-flap |
psecure-violation | security-violation | udld | vmps} | {interval interval}
Syntax Description cause Enable the error-disabled mechanism to recover from a specific cause.
all Enable the timer to recover from all error-disabled causes.
bpduguard Enable the timer to recover from the bridge protocol data unit (BPDU) guard
error-disabled state.
arp-inspection Enable the timer to recover from the Address Resolution Protocol (ARP)
inspection error-disabled state.
channel-misconfig Enable the timer to recover from the EtherChannel misconfiguration
error-disabled state.
dhcp-rate-limit Enable the timer to recover from the DHCP snooping error-disabled state.
dtp-flap Enable the timer to recover from the Dynamic Trunking Protocol (DTP) flap
error-disabled state.
gbic-invalid Enable the timer to recover from an invalid Gigabit Interface Converter
(GBIC) module error-disabled state.
Note On the Catalyst 3560 switch, this error refers to an invalid small
form-factor pluggable (SFP) error-disabled state.
l2ptguard Enable the timer to recover from a Layer 2 protocol tunnel error-disabled
state.
link-flap Enable the timer to recover from the link-flap error-disabled state.
loopback Enable the timer to recover from a loopback error-disabled state.
pagp-flap Enable the timer to recover from the Port Aggregation Protocol (PAgP)-flap
error-disabled state.
psecure-violation Enable the timer to recover from a port security violation disable state.
security-violation Enable the timer to recover from an IEEE 802.1x-violation disabled state.
udld Enable the timer to recover from the UniDirectional Link Detection (UDLD)
error-disabled state.

Cisco WS-C3560E-24PD-E Specifications

General

Brand	Cisco
Model	WS-C3560E-24PD-E
Category	Switch
Language	English