Cisco WS-C3560E-24PD-E User Manual

C-8
Catalyst 3560 Switch Command Reference
78-16405-05
Appendix C Catalyst 3560 Switch Show Platform Commands
show platform frontend-controller
show platform frontend-controller
Use the show platform frontend-controller privileged EXEC command to display counter and status
information for the front-end controller manager and subordinate applications and to display the
hardware and software information for the front-end controller.
show platform frontend-controller {buffer | generic | manager number | subordinate number |
version number} [ | {begin | exclude | include} expression]
This command is supported only on Catalyst 3560G-48TS, 3560G-48PS, 3560G-24TS, and
3560G-24PS switches.
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines On the Catalyst 3560G-48TS and 3560G-48PS switches, the subordinate number range is 0 to 2.
On the Catalyst 3560G-24TS and 3560G-24PS switches, the subordinate number range is 0 to 1.
You should use this command only when you are working directly with a technical support representative
while troubleshooting a problem. Do not use this command unless a technical support representative asks
you to do so.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
buffer Display the last 1024 bytes sent from the manager to the subordinate and the
reverse.
generic Display the generic counters that do not specifically apply to the manager or
subordinate.
manager number Display the counters for the manager and the subordinate specified by
number. See the “Usage Guidelines” section for the number range.
subordinate number Display the subordinate status and the counters for the subordinate specified
by number. See the “Usage Guidelines” section for the number range.
version number Display the hardware and software version information for the subordinate
status specified by number. See the “Usage Guidelines” section for the
number range.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(20)SE3 This command was introduced.

Cisco WS-C3560E-24PD-E Specifications

General

Brand	Cisco
Model	WS-C3560E-24PD-E
Category	Switch
Language	English