B-5
Catalyst 3560 Switch Command Reference
78-16405-05
Appendix B Catalyst 3560 Switch Debug Commands
debug cluster
debug cluster
Use the debug cluster privileged EXEC command to enable debugging of cluster-specific events. Use
the no form of this command to disable debugging.
debug cluster {discovery | events | extended | hsrp | http | ip [packet] | members | nat | neighbors
| platform | snmp | vqpxy}
no debug cluster {discovery | events | extended | hsrp | http | ip [packet] | members | nat |
neighbors | platform | snmp | vqpxy}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines This command is available only on the cluster command switch.
The undebug cluster command is the same as the no debug cluster command.
discovery Display cluster discovery debug messages.
events Display cluster event debug messages.
extended Display extended discovery debug messages.
hsrp Display the Hot Standby Router Protocol (HSRP) debug messages.
http Display Hypertext Transfer Protocol (HTTP) debug messages.
ip [packet] Display IP or transport packet debug messages.
members Display cluster member debug messages.
nat Display Network Address Translation (NAT) debug messages.
neighbors Display cluster neighbor debug messages.
platform Display platform-specific cluster debug messages.
snmp Display Simple Network Management Protocol (SNMP) debug messages.
vqpxy
Display VLAN Query Protocol (VQP) proxy debug messages.
Release Modification
12.1(19)EA1 This command was introduced.
To Next Page
Loading...
Need help?
General