2-379
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
show controllers utilization
show controllers utilization
Use the show controllers utilization user EXEC command to display bandwidth utilization on
the switch or specific ports.
show controllers [interface-id] utilization [ | {begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
Examples This is an example of output from the show controllers utilization command.
Switch> show controllers utilization
Port Receive Utilization Transmit Utilization
Fa0/1 0 0
Fa0/2 0 0
Fa0/3 0 0
Fa0/4 0 0
Fa0/5 0 0
Fa0/6 0 0
Fa0/7 0 0
<output truncated>
<output truncated>
Switch Receive Bandwidth Percentage Utilization : 0
Switch Transmit Bandwidth Percentage Utilization : 0
Switch Fabric Percentage Utilization : 0
This is an example of output from the show controllers utilization command on a specific port:
Switch> show controllers gigabitethernet0/1 utilization
Receive Bandwidth Percentage Utilization : 0
Transmit Bandwidth Percentage Utilization : 0
interface-id (Optional) ID of the switch interface.
| begin (Optional) Display begins with the line that matches the specified expression.
| exclude (Optional) Display excludes lines that match the specified expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.2(25)SE This command was introduced.
To Next Page
Loading...
Need help?
General