B-13
Catalyst 3560 Switch Command Reference
78-16405-05
Appendix B Catalyst 3560 Switch Debug Commands
debug ip dhcp snooping
debug ip dhcp snooping
Use the debug ip dhcp snooping privileged EXEC command to enable debugging of DHCP snooping.
Use the no form of this command to disable debugging.
debug ip dhcp snooping {mac-address | agent | event | packet}
no debug ip dhcp snooping {mac-address | agent | event | packet}
This command is available only if your switch is running the IP services image, formerly known as the
enhanced multilayer image (EMI).
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug ip dhcp snooping command is the same as the no debug ip dhcp snooping command.
Related Commands
mac-address Display debug messages for a DHCP packet with the specified MAC address.
agent Display debug messages for DHCP snooping agents.
event Display debug messages for DHCP snooping events.
packet Display debug messages for DHCP snooping.
Release Modification
12.2(20)SE This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are
enabled. For syntax information, select Cisco IOS Release 12.2
Configuration Guides and Command References > Cisco IOS
Configuration Fundamentals Configuration Guide,
Release 12.2 > System Management > Troubleshooting and
Fault Management.
To Next Page
Loading...
Need help?
General