EasyManua.ls Logo

Cisco WS-C3560E-24PD-E

Cisco WS-C3560E-24PD-E
914 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
C-12
Catalyst 3560 Switch Command Reference
78-16405-05
Appendix C Catalyst 3560 Switch Show Platform Commands
show platform ip unicast
show platform ip unicast
Use the show platform ip unicast privileged EXEC command to display platform-dependent IP unicast
routing information.
show platform ip unicast {adjacency | cef-idb | counts | dhcp | failed {adjacency | arp [A.B.C.D]
| route} | loadbalance | mpaths | proxy | route | standby | statistics | table | trace} [ | {begin
| exclude | include} expression]
Syntax Description
Command Modes Privileged EXEC
Command History
adjacency Display the platform adjacency database.
cef-idb Display platform information corresponding to Cisco Express Forwarding
(CEF) interface descriptor block.
counts Display the current counts for the Layer 3 unicast databases.
dhcp Display the DHCP system dynamic addresses.
failed {adjacency |
arp [A.B.C.D] | route}
Display the hardware resource failures. The keywords have these meanings:
adjacency—Display the adjacency entries that failed to be programmed
in hardware.
arp—Display the Address Resolution Protocol (ARP) deletions because
of failure and because of retries.
A.B.C.D(Optional) Prefix of the ARP entries to display.
route—Display the route entries that failed to be programmed in
hardware.
loadbalance Display the platform loadbalance database.
mpaths Display the Layer 3 unicast routing multipath adjacency database.
proxy Display the platform proxy ARP database.
route Display the platform route database.
standby Display the platform standby information.
statistics Display the Layer 3 unicast routing accumulated statistics.
table Display the platform IP version 4 (IPv4) information.
trace Display the platform event trace logs.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(19)EA1 This command was introduced.

Table of Contents

Related product manuals