B-34
Catalyst 3560 Switch Command Reference
78-16405-05
Appendix B Catalyst 3560 Switch Debug Commands
debug platform dot1x
debug platform dot1x
Use the debug platform dot1x privileged EXEC command to enable debugging of 802.1x events. Use
the no form of this command to disable debugging.
debug platform dot1x {initialization | interface-configuration | rpc}
no debug platform dot1x {initialization | interface-configuration | rpc}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug platform dot1x command is the same as the no debug platform dot1x command.
Related Commands
initialization Display 802.1x initialization sequence debug messages.
interface-configuration Display 802.1x interface configuration-related debug messages.
rpc Display 802.1x remote procedure call (RPC) request debug messages.
Release Modification
12.1(19)EA1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled. For
syntax information, select Cisco IOS Release 12.2 Configuration Guides
and Command References > Cisco IOS Configuration Fundamentals
Configuration Guide, Release 12.2 > System Management >
Troubleshooting and Fault Management.
To Next Page
Loading...
Need help?
General