2-475
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
show mac address-table static
show mac address-table static
Use the show mac address-table static user EXEC command to display only static MAC address table
entries.
show mac address-table static [address mac-address] [interface interface-id] [vlan vlan-id]
[ | {begin | exclude | include} expression]
Syntax Description
Command Modes User EXEC
Command History
Usage Guidelines Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
address mac-address (Optional) Specify a 48-bit MAC address; the valid format is H.H.H
(available in privileged EXEC mode only).
interface interface-id (Optional) Specify an interface to match; valid interfaces include physical
ports and port channels.
vlan vlan-id (Optional) Display addresses for a specific VLAN. The range is 1 to 4094.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(19)EA1 This command was introduced.
To Next Page
Loading...
Need help?
General