2-345
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
show access-lists
show access-lists
Use the show access-lists privileged EXEC command to display access control lists (ACLs) configured
on the switch.
show access-lists [name | number | hardware counters | ipc] [ | {begin | exclude | include}
expression]
Syntax Description
Note Though visible in the command-line help strings, the rate-limit keywords are not supported.
Command Modes Privileged EXEC
Command History
Usage Guidelines The switch supports only IP standard and extended access lists. Therefore, the allowed numbers are only
1 to 199 and 1300 to 2699.
This command also displays the MAC ACLs that are configured.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
name (Optional) Name of the ACL.
number (Optional) ACL number. The range is 1 to 2699.
hardware counters (Optional) Display global hardware ACL statistics for switched and
routed packets.
ipc (Optional) Display Interprocess Communication (IPC) protocol
access-list configuration download information.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(19)EA1 This command was introduced.
To Next Page
Loading...
Need help?
General