2-344
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
setup express
Examples This example shows how to enable Express Setup mode:
Switch(config)# setup express
You can verify that Express Setup mode is enabled by pressing the Mode button:
• On an unconfigured switch, the LEDs above the Mode button turn solid green after 3 seconds.
• On a configured switch, the mode LEDs begin blinking after 2 seconds and turn solid green after 10
seconds.
Caution If you hold the Mode button down for a total of 10 seconds, the configuration is deleted, and the switch
reboots.
This example shows how to disable Express Setup mode:
Switch(config)# no setup express
You can verify that Express Setup mode is disabled by pressing the Mode button. The mode LEDs do
not turn solid green or begin blinking green if Express Setup mode is not enabled on the switch.
Related Commands Command Description
show setup express Displays if Express Setup mode is active.
To Next Page
Loading...
Need help?
General