B-38
Catalyst 3560 Switch Command Reference
78-16405-05
Appendix B Catalyst 3560 Switch Debug Commands
debug platform frontend-controller
debug platform frontend-controller
Use the debug platform frontend-controller privileged EXEC command to enable debugging of
front-end controller activity. Use the no form of this command to disable debugging.
debug platform frontend-controller {all | image | led | manager | poe | register | thermal}
no debug platform frontend-controller {all | image | led | manager | poe | register | thermal}
Syntax Description
Defaults Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines This command is only supported on Catalyst 3560G-48TS, 3560G-48PS, 3560G-24TS, and
3560G-24PS switches.
The undebug platform frontend-controller command is the same as the no debug platform
frontend-controller command.
all Display all the debug messages for front-end controller.
image Display Image Manager debug messages.
led Display LED debug messages.
manager Display front-end-controller manager debug messages.
poe Display Power over Ethernet (PoE) debug messages.
register Display Register Access debug messages.
thermal Display thermal debug messages.
Release Modification
12.2(20)SE3 This command was introduced.
To Next Page
Loading...
