2-179
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
ip verify source
ip verify source
Use the ip verify source interface configuration command to enable IP source guard on an interface. Use
the no form of this command to disable IP source guard.
ip verify source [port-security]
no ip verify source
Syntax Description
Defaults IP source guard is disabled.
Command Modes Interface configuration
Command History
Usage Guidelines To enable IP source guard with source IP address filtering, use the ip verify source interface
configuration command.
To enable IP source guard with source IP and MAC address filtering, use the ip verify source
port-security interface configuration command.
To enable IP source guard with source IP and MAC address filtering, you must enable port security on
the interface.
Examples This example shows how to enable IP source guard with source IP address filtering:
Switch(config-if)# ip verify source
This example shows how to enable IP source guard with source IP and MAC address filtering:
Switch(config-if)# ip verify source port-security
You can verify your settings by entering the show ip source binding privileged EXEC command.
Related Commands
port-security (Optional) Enable IP source guard with IP and MAC address filtering.
If you do not enter the port-security keyword, IP source guard with IP
address filtering is enabled.
Release Modification
12.2(20)SE This command was introduced.
Command Description
ip source binding Configures static bindings on the switch.
show ip verify source Displays the IP source guard configuration on the switch or on a
specific interface.
To Next Page
Loading...
Need help?
General