C-18
Catalyst 3560 Switch Command Reference
78-16405-05
Appendix C Catalyst 3560 Switch Show Platform Commands
show platform layer4op
show platform layer4op
Use the show platform layer4op privileged EXEC command to display platform-dependent Layer 4
operator information.
show platform layer4op {acl | pacl [port-asic] | qos [port-asic]} {and-or | map | or-and | vcu} [
| {begin | exclude | include} expression]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines You should use this command only when you are working directly with a technical support representative
while troubleshooting a problem. Do not use this command unless a technical support representative asks
you to do so.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
do not appear, but the lines that contain Output appear.
acl Display access control list (ACL) Layer 4 operators information.
pacl [port-asic] Display port ACL Layer 4 operators information. The keyword has this meaning:
• port-asic—(Optional) Port ASIC number.
qos [port-asic] Display quality of service (QoS) Layer 4 operators information. The keyword has
this meaning:
• port-asic—(Optional) QoS port ASIC number.
and-or Display AND-OR registers information.
map Display select map information.
or-and Display OR-AND registers information.
vcu Display value compare unit (VCU) register information.
| begin (Optional) Display begins with the line that matches the expression.
| exclude (Optional) Display excludes lines that match the expression.
| include (Optional) Display includes lines that match the specified expression.
expression Expression in the output to use as a reference point.
Release Modification
12.1(19)EA1 This command was introduced.
To Next Page
Loading...
Need help?
General