EasyManuals Logo

Cisco WS-C3560E-24PD-E User Manual

Cisco WS-C3560E-24PD-E
914 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #141 background imageLoading...
Page #141 background image
2-109
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
errdisable detect cause
Usage Guidelines A cause (all, dhcp-rate-limit, and so forth) is the reason why the error-disabled state occurred. When a
cause is detected on an interface, the interface is placed in an error-disabled state, an operational state
that is similar to a link-down state.
If you set a recovery mechanism for the cause by entering the errdisable recovery global configuration
command for the cause, the interface is brought out of the error-disabled state and allowed to retry the
operation when all causes have timed out. If you do not set a recovery mechanism, you must enter the
shutdown and then the no shutdown commands to manually recover an interface from the
error-disabled state.
Examples This example shows how to enable error-disabled detection for the link-flap error-disabled cause:
Switch(config)# errdisable detect cause link-flap
You can verify your setting by entering the show errdisable detect privileged EXEC command.
Related Commands Command Description
show errdisable detect Displays error-disabled detection information.
show interfaces status err-disabled Displays interface status or a list of interfaces in the
error-disabled state.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco WS-C3560E-24PD-E and is the answer not in the manual?

Cisco WS-C3560E-24PD-E Specifications

General IconGeneral
BrandCisco
ModelWS-C3560E-24PD-E
CategorySwitch
LanguageEnglish

Related product manuals