1-2
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 1 Using the Command-Line Interface
CLI Command Modes
Table 1-1 lists the main command modes, how to access each mode, the prompt you see in that mode,
and how to exit that mode. The prompts listed use the default name Switch.
Table 1-1 Command Modes Summary
Command Mode Access Method Prompt Exit or Access Next Mode
User EXEC This is the first level of access.
(For the switch) Change terminal
settings, perform basic tasks, and
list system information.
Switch>
Enter the logout command.
To enter privileged EXEC mode, enter
the enable command.
Privileged EXEC From user EXEC mode, enter the
enable command.
Switch#
To exit to user EXEC mode, enter the
disable command.
To enter global configuration mode,
enter the configure command.
Global
configuration
From privileged EXEC mode,
enter the configure command.
Switch(config)#
To exit to privileged EXEC mode,
enter the exit or end command, or
press Ctrl-Z.
To enter interface configuration mode,
enter the interface configuration
command.
Interface
configuration
From global configuration mode,
specify an interface by entering
the interface command followed
by an interface identification.
Switch(config-if)#
To exit to privileged EXEC mode,
enter the end command, or press
Ctrl-Z.
To exit to global configuration mode,
enter the exit command.
Config-vlan In global configuration mode,
enter the vlan vlan-id command.
Switch(config-vlan)#
To exit to global configuration mode,
enter the exit command.
To return to privileged EXEC mode,
enter the end command, or press
Ctrl-Z.
VLAN
configuration
From privileged EXEC mode,
enter the vlan database
command.
Switch(vlan)#
To exit to privileged EXEC mode,
enter the exit command.
Line configuration From global configuration mode,
specify a line by entering the line
command.
Switch(config-line)#
To exit to global configuration mode,
enter the exit command.
To return to privileged EXEC mode,
enter the end command, or press
Ctrl-Z.
To Next Page
Loading...
Need help?
General