2-332
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
sdm prefer
Examples This example shows how to configure the access template on a switch:
Switch(config)# sdm prefer access
Switch(config)# exit
Switch# reload
This example shows how to configure the routing template on a switch:
Switch(config)# sdm prefer routing
Switch(config)# exit
Switch# reload
This example shows how to configure the dual IPv4-and-IPv6 default template on a switch:
Switch(config)# sdm prefer dual-ipv4-and-ipv6 default
Switch(config)# exit
Switch# reload
This example shows how to change a switch template to the default template.
Switch(config)# no sdm prefer
Switch(config)# exit
Switch# reload
You can verify your settings by entering the show sdm prefer privileged EXEC command.
Related Commands
Total IPv6 unicast routes: 3 K 0
• Directly connected IPv6 addresses 2 K 0
• Indirect IPv6 unicast routes 1 K 0
IPv4 policy-based routing ACEs 0 0
IPv4 or MAC QoS ACEs (total) 512 512
IPv4 or MAC security ACEs (total) 1 K 1 K
IPv6 policy-based routing ACEs 0 0
IPv6 QoS ACEs 510 510
IPv6 security ACEs 510 510
Table 2-16 Approximate Feature Resources Allowed by Dual IPv4-IPv6 Templates (continued)
Resource Default VLAN
Command Description
show sdm prefer Displays the current SDM template in use or displays the templates that can
be used, with approximate resource allocation per feature.
To Next Page
Loading...
Need help?
General