2-385
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
show dot1x
AuthFail-Vlan = 1001
AuthFail-Max-Attempts = 3
Critical Port = Enabled
This is an example of output from the show dot1x statistics interface interface-id command. Table 2-22
describes the fields in the display.
Switch# show dot1x statistics interface gigabitethernet0/1
PortStatistics Parameters for Dot1x
--------------------------------------------
TxReqId = 15 TxReq = 0 TxTotal = 15
RxStart = 4 RxLogoff = 0 RxRespId = 1 RxResp = 1
RxInvalid = 0 RxLenErr = 0 RxTotal= 6
RxVersion = 1 LastRxSrcMac 00d0.b71b.35de
Related Commands
Table 2-22 show dot1x statistics Field Descriptions
Field Description
TxReqId Number of Extensible Authentication Protocol (EAP)-request/identity frames
that have been sent.
TxReq Number of EAP-request frames (other than request/identity frames) that have
been sent.
TxTotal Number of Extensible Authentication Protocol over LAN (EAPOL) frames of any
type that have been sent.
RxStart Number of valid EAPOL-start frames that have been received.
RxLogoff Number of EAPOL-logoff frames that have been received.
RxRespId Number of EAP-response/identity frames that have been received.
RxResp Number of valid EAP-response frames (other than response/identity frames) that
have been received.
RxInvalid Number of EAPOL frames that have been received and have an unrecognized
frame type.
RxLenError Number of EAPOL frames that have been received in which the packet body
length field is invalid.
RxTotal Number of valid EAPOL frames of any type that have been received.
RxVersion Number of received packets in the IEEE 802.1x Version 1 format.
LastRxSrcMac Source MAC address carried in the most recently received EAPOL frame.
Command Description
dot1x default Resets the IEEE 802.1x parameters to their default values.
To Next Page
Loading...
Need help?
General