2-456
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
show lacp
This is an example of output from the show lacp neighbor command:
Switch> show lacp neighbor
Flags: S - Device is sending Slow LACPDUs F - Device is sending Fast LACPDUs
A - Device is in Active mode P - Device is in Passive mode
Channel group 3 neighbors
Partner’s information:
Partner Partner Partner
Port System ID Port Number Age Flags
Gi0/1 32768,0007.eb49.5e80 0xC 19s SP
LACP Partner Partner Partner
Port Priority Oper Key Port State
32768 0x3 0x3C
Partner’s information:
Partner Partner Partner
Port System ID Port Number Age Flags
Gi0/2 32768,0007.eb49.5e80 0xD 15s SP
LACP Partner Partner Partner
Port Priority Oper Key Port State
32768 0x3 0x3C
This is an example of output from the show lacp sys-id command:
Switch> show lacp sys-id
32765,0002.4b29.3a00
The system identification is made up of the system priority and the system MAC address. The first two
bytes are the system priority, and the last six bytes are the globally administered individual MAC address
associated to the system.
Related Commands Command Description
clear lacp Clears the LACP channel-group information.
lacp port-priority Configures the LACP port priority.
lacp system-priority Configures the LACP system priority.
To Next Page
Loading...
Need help?
General