2-37
Catalyst 3560 Switch Command Reference
78-16405-05
Chapter 2 Catalyst 3560 Switch Cisco IOS Commands
class-map
Only one access control list (ACL) can be configured in a class map. The ACL can have multiple access
control entries (ACEs).
Examples This example shows how to configure the class map called class1 with one match criterion, which is an
access list called 103:
Switch(config)# access-list 103 permit any any dscp 10
Switch(config)# class-map class1
Switch(config-cmap)# match access-group 103
Switch(config-cmap)# exit
This example shows how to delete the class map c
lass1
:
Switch(config)# no class-map class1
You can verify your settings by entering the show class-map privileged EXEC command.
Related Commands Command Description
class Defines a traffic classification match criteria (through the police,
set, and trust policy-map class configuration commands) for the
specified class-map name.
match (class-map
configuration)
Defines the match criteria to classify traffic.
policy-map Creates or modifies a policy map that can be attached to multiple
ports to specify a service policy.
show class-map Displays QoS class maps.
To Next Page
Loading...
Need help?
General