Index
IN-3
Catalyst 3560 Switch Command Reference
78-16405-05
cluster member command 2-60
cluster outside-interface command 2-62
cluster requirements xxi
cluster run command 2-63
clusters
adding candidates
2-60
binding to HSRP group 2-64
building manually 2-60
communicating with
devices outside the cluster
2-62
members by using Telnet 2-323
debug messages, display B-5
displaying
candidate switches
2-362
debug messages B-5
member switches 2-364
status 2-360
hop-count limit for extended discovery 2-56
HSRP standby groups 2-64
redundancy 2-64
SNMP trap 2-551
cluster standby-group command 2-64
cluster timer command 2-66
command modes defined 1-1
commands changed in Cisco IOS Release 12.2(20)SE 1-6
command switch
See clusters
configuration, initial
See getting started guide and hardware installation guide
configuration files
password recovery disable considerations
A-1
specifying the name 2-23, 2-28
configuring multiple interfaces 2-118
config-vlan mode
commands
2-669
description 1-4
entering 2-668
summary 1-2
conventions
command
xx
for examples xx
publication xx
text xx
copy (boot loader) command A-5
CoS
assigning default value to incoming packets
2-242
assigning to Layer 2 protocol packets 2-202
overriding the incoming value 2-242
CoS-to-DSCP map 2-246
CPU ASIC statistics, displaying 2-366
crashinfo files 2-113
D
debug auto qos command B-2
debug backup command B-4
debug cluster command B-5
debug dot1x command B-7
debug dtp command B-9
debug etherchannel command B-10
debug ilpower command B-12
debug interface command B-15
debug ip dhcp snooping command B-13
debug ip igmp filter command B-17
debug ip igmp max-groups command B-18
debug ip igmp snooping command B-19
debug ip verify source packet command B-14
debug lacp command B-20
debug mac-notification command B-21
debug matm command B-22
debug matm move update command B-23
debug monitor command B-24
debug mvrdbg command B-26
debug nvram command B-27
debug pagp command B-28
debug platform acl command B-29
debug platform backup interface command B-30