Cisco WS-C3560E-24PD-E - Page 899

Index
IN-5
Catalyst 3560 Switch Command Reference
78-16405-05
dot1x auth-fail max-attempts 2-82
dot1x auth-fail vlan 2-84
dot1x command 2-80
dot1x control-direction command 2-86
dot1x critical command 2-88
dot1x default command 2-90
dot1x guest-vlan command 2-91
dot1x host-mode command 2-93
dot1x initialize command 2-95
dot1x max-req command 2-96, 2-97
dot1x multiple-hosts command 2-98
dot1x port-control command 2-99
dot1x re-authenticate command 2-101
dot1x re-authentication command 2-102
dot1x reauthentication command 2-103
dot1x timeout command 2-104
dropping packets, with ACL matches 2-5
drop threshold, Layer 2 protocol tunneling 2-199
DSCP-to-CoS map 2-246
DSCP-to-DSCP-mutation map 2-246
DTP 2-627
DTP flap
error detection for
2-108
error recovery timer 2-110
DTP negotiation 2-631
dual IPv4 and IPv6 templates 2-292
duplex command 2-106
dynamic-access ports
configuring
2-620
restrictions 2-621
dynamic ARP inspection
ARP ACLs
apply to a VLAN
2-127
define 2-15
deny packets 2-70
display 2-349
permit packets 2-290
dynamic ARP inspection (continued)
clear
log buffer
2-38
statistics 2-39
display
ARP ACLs
2-349
configuration and operating state 2-414
log buffer 2-414
statistics 2-414
trust state and rate limit 2-414
enable per VLAN 2-137
error detection for 2-108
error recovery timer 2-110
log buffer
clear
2-38
configure 2-131
display 2-414
rate-limit incoming ARP packets 2-129
statistics
clear
2-39
display 2-414
trusted interface state 2-133
type of packet logged 2-138
validation checks 2-135
dynamic auto VLAN membership mode 2-626
dynamic desirable VLAN membership mode 2-626
Dynamic Host Configuration Protocol (DHCP)
See DHCP snooping
Dynamic Trunking Protocol
See DTP
E
EAP-request/identity frame
maximum number to send
2-97
response time before retransmitting 2-104
encapsulation methods 2-646
environment variables, displaying 2-354
errdisable detect cause command 2-108