Citizen CT-S300 - Cutter Commands; ESC I

Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 151 -
2.2.11 Cutter Commands
ESC i
[Function] Full cutting of paper
[Code] <1B>H<69>H
[Outline] [The specification which is common to the model]
• Executes full cutting of paper.
[Caution] [The specification which is common to the model]
• This command only works it is entered at the beginning of a line.
• Before cutting paper, feed the paper more than the cutting position of paper from the print position. Without
this paper feeding, the character just after printing remains before the cutter.
MSW4-8=ON: This command works as partial cut command.
[The specification which depend on the model]
CT-S281/CT-S300/CT-S310/CT-S2000/CT-S4000/
CT-S801(II)/CT-S851(II)
• With label- or BM-supported model, this command does not function at the setting of BM
paper/label paper setting.
[Sample Program] [Print Results]
Cut state
LPRINT “AAAAA”;
LPRINT CHR$(&H1B);"J";
LPRINT CHR$(150);
LPRINT CHR$(&H1B);"i";
AAAAA
Cut position
AAAAA
Paper feed
direction