Citizen CT-S300 - Msw2

- 467 -
4.2.2 MSW2
●MSW2-1: Reserved [Fixed to ON(1)]
●MSW2-2: Auto-cutter operation
[Outline] Select auto-cutter enable/disable.
OFF(0)
ON(１)
Auto Cutter
Invalid
Valid
ON (1) OPERATION: Auto-cutter enabled
OFF (0) OPERATION: Auto-cutter disabled
●MSW2-3: Buffering
[Outline] Select buffering print enable/disable.
OFF(0)
ON(1)
Spool Print
Invalid
Valid
ON (1) OPERATION: Buffering print is enabled. Buffering print means that save a certain amount of print buffer
to internal RAM for collective printing
・ Save a certain amount of print buffer to internal RAM for collective printing.
・ If cut command such as GS+V ESC+i ESC +m are entered, print starts even
before the specified amount is reached. FF or GS+FF command In Black mark
mode or label model works same way.
・ Even if no cut command is entered and the entered data does not reach the
specified amount, entered data to print buffer is printed after no new data comes to
print buffer for certain period.
OFF (0) OPERATION: Buffering print is disabled.