Citizen CT-S300 - ESC M

Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 152 -
ESC m
[Function] Partial cutting of paper
[Code] <1B>H<6D>H
[Outline] [The specification which is common to the model]
• Executes partial cutting of paper.
[Caution] [The specification which is common to the model]
• This command only works it is entered at the beginning of a line.
• Before cutting paper, feed the paper more than the cutting position of paper from the print position. Without
this paper feeding, the character just after printing remains before the cutter.
[The specification which depend on the model]
CT-S281/ CT-S300/CT-S310/CT-S2000/CT-S4000/
CT-S801(II)/CT-S851(II)
• With label- or BM-supported model, this command does not function at the setting of BM
paper/label paper setting.
[Sample Program] [Print Results]
Cut state
LPRINT “AAAAA”;
LPRINT CHR$(&H1B);"J";
LPRINT CHR$(150);
LPRINT CHR$(&H1B);"m";
AAAAA
Cut position
AAAAA
Paper feed
direction