Citizen CT-S300 - GS V M; GS V M N

Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 153 -
GS V m --- (1)
GS V m n --- (2)
[Function] Cutting the paper
[Code] (1)<1D>H<56>H<m>
(2)<1D>H<56>H<m><n>
[Range] (1)0≤m≤1, 48≤m≤49
(2)m=65, 66
0≤n≤255
[Outline] [The specification which is common to the model]
• Performs the specified paper cutting.
m
Function
0, 48
Full cut
1, 49
Partial cut (Leaving a bridge area uncut)
65
Paper feed by “cut position + {n×basic calculation pitch}” and full cut
66
Paper feed by “cut position + {n×basic calculation pitch}” and partial cut
[Caution] [The specification which is common to the model]
• In STANDARD MODE, this command only works when it is entered at the beginning of a line.
• Control to make the length of cut paper less than 10 mm is not executed.
For (1):
• Executes cutting of paper.
For (2):
• If n = 0, the paper is fed to the cut position, and then cut. If n ≠
0, the pape
pitch” inches past the cut position, and then cut.
• The basic calculation pitch is set by GS P. The paper feed amount is calculated with the vertical basic
calculation pitch (y). A fraction resulting from the calculation is corrected with the minimum pitch of the
mechanism, and the remainder is omitted.
MSW4-8=ON: This command works as partial cut command only.
[The specification which depend on the model]
CT-S281/CT-S300/CT-S310/CT-S2000/CT-S4000/
CT-S801(II)/CT-S851(II)
• With label- or BM-supported model, this command does not function at the setting of BM
paper/label paper setting.