Citizen CT-S300 - ESC & S N M [ a [P] S X a ] M-N+1

Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 74 -
ESC & s n m [ a [p] s x a ] m-n+1
[Function] Defining the download characters
[Code] <1B>H<26>H<s>H<n>H<m>H [<a>H<p1>H<p2>---<ps×a>] m-n+1
[Range] s=3(Font A, B), s=2(Font C)
32≤n≤m≤126
0≤a≤12(Font A)
0≤a≤9 (Font B)
0≤a≤8 (Font C)
0≤p1--ps×a≤255
[Outline] [The specification which is common to the model]
• Defines the font of download characters of alphanumeric characters.
• “s” indicates the number of bytes in vertical direction.
• “n” indicates the start character code and “m” the end character code. To define only one character, set n =
m.
• Character codes definable includes 95 ASCII codes in total in the range of 20H to 7EH.
• “a” indicates the number of dots to be defined in horizontal direction.
• “p” is the data to be defined, which indicate a pattern equal to “a” dots in horizontal direction from the left end.
The rest of the pattern on the right side is filled with space.
• The number of data to be defined is “s × a ”.
• Download characters thus defined remain valid until redefinition, execution of ESC @, GS *, FS q, GS (A,
deletion by ESC ?, or power OFF is performed.
[Caution] [The specification which depend on the model]
CT-S280/CT-S281/CT-S300/CT-S310/CT-P29x series
• Running this command clears the definition of the download bit image.
CT-S2000/CT-S4000 / CT-S801(II)/CT-S851(II)/CT-S601(II)/CT-S651(II) /
CT-S251/CT-D151/CT-E651
• Running this command doesn't clear the definition of the download bit image.
[Default]
Same as the internal character set.
[See Also] ESC %, ESC ?