Support
model
CT-S280 CT-S300 CT-S2000 CT-S4000 CT-S251 CT-D150/E351
- 209 -
CT-S280
• Setting MSW 1 (a=1)
1
Does not report power on.
2
48 (Default) Sets input buffer capacity to 4K bytes.
49 Sets input buffer capacity to 45 bytes.
3
Sets input buffer full and offline to be Busy.
Sets to be busy with input buffer full.
4
48 (Default)
At the occurrence of receiving error, replaces the data with
“?”.
At the occurrence of receiving error, ignores the data.
5
7
Does not reset at serial I/F pin 6.
Resets at serial I/F pin 6.
• Setting MSW 2 (a=2)
2 48(Default) Reserved
3
48 (Default) Enables stored printing.
49 Disables stored printing.
4
Immediately after digit reaches full, line-feed is taken.
Immediately after digit reaches full, data wait is taken.
5
After cover close and PE recovery, prints as it is.
49
After cover close and PE recovery, prints from the
beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.
8
• Setting MSW 3 (a=3)
1 48 (Default) Reserved
3
48 (Default) Resets with parallel pin 31.
49 Does not reset with parallel pin 31.
Sets CBM270-noncompatible mode.
Sets CBM270-compatible mode.
8
48 (Default)
Sets cover open error during printing to be auto recovery
error.
49
Sets cover open error during printing to be recoverable
error.