Multi-Appliance Touch Pad Control
PNE2002 Series Control
Page 10
Navi
atin
the Controls
ADJUSTMENT ARROWS
The adjustment arrows can be used to increase or decrease
the function of product being controlled. The icons will come
on automatically to indicate the units mode of operation.
R
ESET / FAULT CODE
If the reset icon appears and the touchpad thermostat is
flashing information in clock area, it means the unit has
stopped as the result of e.g. electricity / gas interruption,
malfunction etc.
The information being displayed will continually rotate
between the unit identification and the fault code e.g. HC:01
and F:04. Before resetting the control, not the fault code
information. Should a service call be required, this will assist
in quick diagnostics and service requirements.
To RESET the unit, press and hold the RESET icon for
approximately 4 seconds until 2 BEEPs have been heard.
The reset icon will disappear and your appliance will be reset.
If there has been no component failure the unit will now
resume it’s function.
I
CONS
The operating icons will be displayed relative to the unit’s operation.
1. Indicator Bars
Evaporative Air Conditioning
(Manual Mode) shows fan speed
(Thermostat Mode) comfort settings.
Central Heaters shows fan speed only.
2. Snow Flake Symbol
For evaporative air conditioning it indicates that the
pump is on or
For Addon Refrigerated Air Conditioning it indicates that
the condenser is operating.
3. Fan Symbol
For Evaporative Air Conditioning it indicates the fan is operating
For Ducted Heating it represents "Summer Fan" mode with the fan operating only
For Addon Refrigerated Cooling it represents continuous fan.
4 Flame Symbol
Indicates that the thermostat is calling for heat from the ducted central heater
To Next Page
Loading...