Climate Technologies Touch Pad Control - Fault Codes for High Efficiency, MID Efficiency Heaters

Multi-Appliance Touch Pad
PNE2004 Series Control
Page 41
Controls – Installation / Setu
p
/ Commissionin
g
FAULT CODES FOR HIGH EFFICIENCY, MID EFFICIENCY HEATERS
Code No. Fault Code Diagnosis
00
No Activity There has been no fault codes registered or the
control has not been coded to the unit.
1
(Mid Effic Only)
Block Flue Check flue cowl installed correctly
2
(Mid Effic. Only)
Pressure Switch fused closed Service Call
3
(Mid Effic Only)
Combustion air pressure system failure Check combustion fan OK.
4
Room air over temperature (auto reset) Check Minimum Fan Speed, Duct design
5
Controller electronic malfunction Reset, Service Call
6
Slow closing gas valve Reset, Service Call
7
Ignition failure Check: - igniter working, flame sensor, gas supply,
blocked flue, blocked condensate drain.
8
Gas Interruption Check gas supply, Service Call
9
EEPROM failure Reset, Service Call
11
Missed Transmission Check loom integrety and connections
12
No Communication (Touch Pad Only) Touchpad cannot detect unit – check loom integrety
and connections
15
No recorded fault codes