Multi-Appliance Touch Pad Control
PNE2002 Series Control
Page 16
Ducted Gas Central Heatin
ZONES
Selecting ZONE 1 2 3 4 only applies if your home is fitted
with optional motorised ductwork dampers (please consult
your installer) that allow opening or closing of each section
of ducting.
Many homes have no motorised ductwork dampers fitted,
however the control will still display the zones. Where
zone motors are fitted the installer can set your controller
to show only the zones available for use.
In homes with more than one zone, the default requires at
least one zone open at all times. The common zone
feature, which allows all zones to be turned off, can only
be applied to specific duct designs. This must ONLY be
set by the installer.
S
ETTING THE OPEN OR CLOSED STATUS
Step 1 To select ZONES switch the Touch Pad Control
ON
Step 2 Ensure the Appliance is set to HEAT and
THERM.
Step 3 Press any where in the ZONE area to see the
available zone icons.
Step 4 To turn a ZONE ON, press the ZONE icon required so that it stops flashing. To turn a ZONE OFF
press the ZONE icon to make it flash. The flashing icons will flash 5 more times and disappear. In
approximately 30 seconds the new zone settings will be effective
P
ROGRAMMING YOUR TOUCH PAD
Programming your Touch Pad will provide energy and time savings. Your heating and or cooling system
will only operate when you need it, and at your chosen comfort levels.
Determine your most comfortable settings, program them and let your Touch Pad do the rest
automatically.
Press the PRGM button in the mode panel to run you selected program..
Programming Sequence
If you've never programmed your Touch Pad control
before (or it’s been a while) remember it's easier to
program the whole week to the same settings (by
selecting the whole week MON TUE WED THU FRI
SAT SUN day choice) and then program variations for
particular days or the weekend as you become more
familiar with programming.
If the Controller exits program mode it may be because you've paused longer than about 60 seconds to
make your next choice. All the settings you've made up to then in a completed program period (Period 1 ,
To Next Page
Loading...