Multi-Appliance Touch Pad Control
PNE2002 Series Control
Page 19
Ducted Gas Central Heatin
PROGRAM OVERRIDE (PGRM)
The program can be overridden within the PGRM period without altering the program setup.
1. To override the PGRM mode when programmed ON or OFF, press and hold the PGRM mode button
for 5 seconds until it beeps and then immediately select one of the mode functions available. The
PGRM button will remain aluminated with your new selection.
2. When the program is ON, the set temperature can be adjusted and the zones (where fitted) can be
changed.
3. The period number will now flash until the next period is activated or the touchpad is turned OFF then
ON.
C
LOCK SETUP
Timer setup will take you through the steps to set your 12-hour clock. You
can use FINISH at any stage of setting the Day and Time.
Step 1 To select the CLOCK setup touch anywhere in the SETUP
outline.
Step 2 Press CLOCK. The 3 icons will disappear and edit mode has
begun.
Step 3 Three new icons will now be displayed ENTER, CANCEL &
FINISH.
• ENTER will save each step of the program
• CANCEL will abort the setup and no entries will be saved.
• FINISH allows you to stop at any time and save the settings.
Step 4 Adjust the hours using the arrows. Press
ENTER
Step 5 Adjust the minutes using the arrows. Press
ENTER.
Step 6 Adjust the day using the arrows. Press
ENTER
Time setup is now complete and all functions are resumed.
S
UMMER SHUTDOWN (OPTIONAL)
Step 1 Switch the Touch Pad OFF
Step 2 Switch the power point OFF and turn the gas tap OFF. They are usually located close to the
Heater.
F
IRST STARTUP OR RESTART AFTER SHUTDOWN
Step 1 Switch on the power point to the heater. Turn on the gas tap on the gas supply line into the
heater.
Step 2 Switch the Touch Pad ON
Step 3 Select HEAT in the Appliance are if not already there.
Step 4 Press button to increase or decrease the SET TEMPERATURE. If the SET
temperature is greater than the room temperature the heater will resume operation.
To Next Page
Loading...