Climate Technologies Touch Pad Control - ZONES - Selecting ZONE 1, 2, 3, or 4; Programming Your Touch Pad; Programming Sequence

Multi-Appliance Touch Pad
PNE2002 Series Control
Page 25
Addon – Refri
g
erated Air Conditionin
g
• As your activities vary, you may find you need different temperature settings, e.g. a
temperature comfortable for sitting is usually too cool compared to when your moving
about.
• For economical operation, set a low SET TEMPERATURE during the day when you are
active. Switch the Touch Pad OFF when asleep and ON again when awake. These cost
saving functions can be programmed to operate automatically (see Programmed Control).
Step 6 Press the ON/OFF button to switch the Add-on Cooler OFF.
Step 7 The Touch Pad remembers your SET TEMPERATURE setting
and uses it next time you turn it ON.
ZONES - S
ELECTING ZONE 1, 2, 3, OR 4
Selecting ZONE 1, 2, 3, 4 applies with add-on air conditioning because
the suitable cooling unit will normally achieve effective cooling in a
smaller portion of your home than compared to the gas heating.
The installer will have set your controller to show the zones you have
available.
In homes with more than one zone, at least one zone must be open at all
times.
To set the open or closed status of a ZONE:
Refer to ZONES - Selecting ZONE 1, 2, 3 or 4 options in the Ducted
Gas Central Heating Section.
P
ROGRAMMING YOUR TOUCH PAD
Programming your Touch Pad will provide energy and time savings. Your
heating/cooling system will only operate when you need it, and at your
chosen comfort levels.
Determine your most comfortable settings, program them and let your
Touch Pad Control do the rest automatically.
P
ROGRAMMING SEQUENCE
Refer to Programming Sequence in the Ducted Gas Central Heating
Section.