Multi-Appliance Touch Pad Control
PNE2002 Series Control
Page 5
Introduction
Introduction
You have chosen one of the world's most advanced control systems incorporating the latest technology.
The Touch Pad control is an Australian and world first for its use with ducted heating and cooling systems.
Designed exclusively for Climate Technologies air comfort products, the self-prompting display panel
controls your unit’s functions, providing the ultimate in heating and cooling flexibility.
This technologically advanced controller comes with manual and thermostat control, programmable timer,
boost function plus many other setup functions.
Your Touchpad Control has been designed to operate the following Climate Technologies products:
Heating – Ducted Gas Central Heaters.
Add-on Cooling - Refrigerated Air Conditioning (cooling only) designed to add-on to Ducted Gas Central
Heaters.
Fresh Air Conditioners - Ducted Evaporative Air Conditioners.
Your Touch Pad Control is designed to automatically detect the appliances during the commissioning of the
unit by the installer. Controller options not required for your appliances will usually not be visible on your
Touch Pad display.
Additional control accessories that can be added to your Touchpad control for enhanced operation include:
Remote Thermostat – an extra thermostat that can be connected in conjunction with the Touchpad to
individually control a zone motor in a specified area of a ducted gas heating system.
Home Automation – allows the unit to be turned ON or OFF from the touch of a telephone or an
independent control system.
Your Touch Pad is designed in Australia to suit Australian conditions and will ensure that your home is
comfortable all year round.
GENERAL INFORMATION.
IMPORTANT INSTALLATION NOTICE.
A licensed person is required to install Climate Technologies equipment. If the equipment is not installed in a
accordance with the installation instructions and the governing body regulations, Climate Technologies
reserves the right to refuse service on non compliant installations.
Subject to state regulations and by laws a certificate of compliance must be issued for the electrical and
plumbing connections certifying that the work complies with all the relevant standards.
Note: Only a licensed person will have insurance protecting their workmanship.
D
ATA LOCATION.
Your appliance model number, serial number and model description are located on the appliance data plate
on the end of the heater or inside the cooler in the vicinity of the electronic controls. These details should
also be in the warranty section of this booklet.
You will need this information, should your appliance require servicing, spare parts or just if you require
additional information about this product.
.
To Next Page
Loading...