Climate Technologies Touch Pad Control - Warranty and Service Information; Warranty Statement, Periods, and Proof of Purchase

Multi-Appliance Touch Pad
PNE2004 Series Control
Page 53
Warrant
y
– Australia
Warranty
APPLIANCE WARRANTY STATEMENT.
Subject to the following conditions Climate Technologies provide, from the dated proof of purchase, the
following warranty:
• Functional components found within the unit to be to be defective in workmanship or material will be replace
free of charge subject to the periods of warranty specified.
• Structural components within the product that fail to perform the intended function due to faulty manufacture or
deterioration will be replaced free of charge subject to the periods of warranty specified.
This warranty only covers products and associated controls covering ducted gas central heating, addon refrigerated
air conditioning and ducted evaporative air conditioning manufactured and supplied by Climate Technologies.
CONDITIONS AND EXCLUSIONS
• Appliance warranty does not cover installation components that may be attached to the product
manufactured by Climate Technologies. These may include and is not limited to items such as ducting, flues,
grills, piping etc. These items remain solely the responsibility of the dealer / installer.
• Product fitness for purpose and overall system design / sizing are solely the responsibility of the dealer /
installer. This includes but is not limited to:
- Evaporative air conditioners - heat load, air flow, system balancing, humidity, water quality etc.
- Central heating / addon cooling - heat load calculations, air flow, system balancing etc.
• Travelling time and mileage are included within 30km of either your authorised Climate Technologies dealer
or service provider’s premises. Customers in areas other than the above are responsible for any travelling
time and mileage required to carry out warranty repairs.
• The product must be installed by a qualified person in the manner prescribed by local & statutory regulations
and to the manufacturer’s specifications.
• Service within the terms of this warranty will be recognised where we are satisfied that the appliance or part
was supplied within the relevant time limits. Documents of purchase and Dealer/Installer information will
assist in this process.
• A charge will be made for work done or a service call where:
- There is nothing wrong with the appliance.
- The defective operation of the appliance is due to failure of electricity or gas or water supply.
- Defects are caused by neglect, incorrect application, abuse or by accidental damage of the appliance.
- An unauthorised person has attempting to repair the appliance.
- A situation arises referenced in the trouble-shooting guide.
• Damage caused by elements such as wind, rain, lighting, floods etc along with power spiking and brownouts
are not considered defective material or workmanship and as such are not considered warranty.
• If there is no certificate of compliance for plumbing or electrical, Climate Technologies reserves the right to
refuse service on non-compliant installations.
• No responsibility will be accepted for outside elements such as pests, animals, pets and vermin that may
cause damage to the unit.
• Harsh environmental situations such as salt air that may cause cabinet or electronic damage can not be
considered warranty.
• Claims for damage to contents, carpet, walls, ceilings, foundations or any other consequential loss either
direct or indirect resulting from, power spikes, incorrect operation, incorrect installation or faulty product are
excluded.
• All warranties are NOT transferable.
NOTE: In addition to this warranty, the Trade Practices Act and similar laws in each state provide the owner, under
certain circumstances, with minimum statutory rights in relation to the product.
This warranty must be read subject to that legislation and nothing in this warranty has the effect of excluding,
restricting or modifying those rights.