Multi-Appliance Touch Pad
PNE2004 Series Control
Page 40
Controls – Installation / Setu
/ Commissionin
STEP 4 Using the arrows select 4
from the LED display. Press ENTER .
COOL will flash in the APPLIANCE area and
the TIME display will alternate between Co dE
and E 01
STEP 5 Using the arrows select the
new unit to be coded from the LED display e.g.
E 01, H 01, HC 01. Press ENTER
STEP 6 Press FINISH to exit.
F
AULT CODES ACCESS
The Touch Pad control can recover the last 5 faults that the unit diagnostics has stored. Fault code 1 is
the current registered fault, while 2, 3, 4 & 5 is the fault code history.
1. At the time of the unit stopping and displaying the RESET icon. Press the RESET icon while the
Touch Pad control is in the ON mode before resetting the unit.
2. Recovering the fault log after the unit has been reset. In the OFF mode press and hold the RESET
icon outline till the numeric screen display changes.
V
IEW THE FAULT CODE
There are a number of fault codes that can be registered subject to the failure or the product associated.
Step 1 Once the fault code log has been entered tP
01 will be displayed.
Step 2 Using the arrows select
the unit that displays the APPLIANCE and
reset icon (Reset Icon is not displayed after the
unit has been reset). Press ENTER.
Step 3 The last fault code number will be displayed
with number 0 and the fault code. Number 0 is
always the most recent fault. See the fault
code table below.
Step 4 Using the arrows, review
fault codes for 0, 1, 2, 3 & 4. Number 0 will be
the most recent.
Step 5 Press FINISH to exit.
Step 6 If the unit has not been reset, press and hold
RESET icon until a BEEP is heard for the unit
to recommence operation.
To Next Page
Loading...