Climate Technologies Touch Pad Control - General Information and Safety

Multi-Appliance Touch Pad
PNE2002 Series Control
Page 23
Addon – Refri
g
erated Air Conditionin
g
General Information.
IMPORTANT NOTICE.
A licensed person is required to install Climate Technologies equipment. If the equipment is not installed
in a accordance with the installation instructions and the governing body regulations, Climate
Technologies reserves the right to refuse service on non compliant installations.
Subject to state regulations and by laws a certificate of compliance must be issued for the electrical and
plumbing connections certifying that the work complies with all the relevant standards.
Note: Only a licensed person will have insurance protecting their workmanship.
D
ATA LOCATION.
Your appliance model number, serial number and model description are located on the appliance data
plate on the end of the ducted gas heater / addon air conditioner in the vicinity of the electronic controls
access. These details should also be in the warranty section of this booklet.
You will need this information, should your appliance require servicing, spare parts or just if you require
additional information about this product.
A
SSEMBLY.
There is no assembly required of this Add-on Refrigerated Air Conditioner. Your Dealer or installer will
carry out all assembly and commissioning upon installation.
Safety
SAFETY & OWNER RESPONSIBILITY
The manufacturer and its service providers reserve the right to refuse service unless safety and
accessibility to the unit can be guaranteed. The cost of any extra equipment required to provide access
to the unit for servicing is the responsibility of the owner.
P
RECAUTIONS.
DO NOT PLACE ARTICLES ON OR AGAINST THE CONDENSER.
DO NOT PLACE ARTICLES IN FRONT OF THE CONDENSER.
ENSURE THE CLEARANCES BETWEEN THE UNIT AND WALL ARE KEPT CLEAR.
DO NOT PLACE ARTICLES IN FRONT OF OR OVER THE RETURN AIR GRILLE.
F
EATURES.
Your Ducted Gas Central Heater and Add-on Refrigerated air conditioner has all the safety devices to
ensure safe operation. These devices conform to the standards set out by the Standards Australia .
P
OWER INTERRUPTION.
Should there be an interruption to the power supply during the cooling operation the controls will
automatically shut down.
Your gas ducted heater and or add-on cooler will automatically resume operation once the power has
been restored.