Multi-Appliance Touch Pad
PNE2004 Series Control
Page 32
Ducted Eva
orative Air Conditionin
Program Setup ……..Continued
Step 8 Adjust the output using the arrows and
press ENTER
Step 9 Program the second period using steps 4
to 8.
Step 10 If only 2 program periods are required
press FINISH. If a 3
rd
period is required
program using Steps 4 to 8.
Step 11 If Only 3 Program Periods Are Required
press FINISH. If a 4
th
period is required
program using Steps 4 to 8.
Program setup is now complete and all
functions are resumed.
Step 12 To use the program, touch the mode area
and select PRGM
C
LOCK SETUP
Timer setup will take you through the steps to set
your evaporative air conditioner
Step 1 To select the CLOCK setup touch anywhere
in the SETUP outline.
Step 2 Press CLOCK. The 3 icons will disappear
and edit mode has begun.
Step 3 Three new icons will now be displayed
ENTER, CANCEL & FINISH.
• ENTER will save each step of the
program
• CANCEL will abort the setup and no
entries will be saved.
• FINISH allows you to stop at any time
and save the settings.
Step 4 Adjust the hours using the
arrows. Press ENTER
Step 5 Adjust the minutes using the
arrows. Press ENTER.
Step 6 Adjust the day using the
arrows. Press ENTER.
Time setup is now complete and all functions are resumed.
Default Setup Evaporative Air Conditioning
Program
Period ON/OFF Start Time Mode
1 ON 6:00 am THERM
2 OFF 9:00 am -
3 ON 4:00 pm THERM
4 OFF 10:00 pm -
To Next Page
Loading...