Multi-Appliance Touch Pad
PNE2002 Series Control
Page 24
Addon – Refri
erated Air Conditionin
Using Your Touch Pad With Addon Air Conditioning
Using your Touch Pad for manual operation of your Add-on Refrigerated Air Conditioner is the same as
your gas central heater where you want direct control, without timers or programming.
M
ANUAL OPERATION
Step 1 Turn the Touch Pad on, press and release the
ON/OFF button. HEAT or COOL may be
displayed in the APPLIANCE area. Select
COOL if not already displayed.
NOTE: Your Touch Pad Control is designed to
automatically detect the appliances you have
installed. Controller options not required for
your appliances will not be visible on your
Touch Pad Control display. So don't worry if
you don't see all the menu items listed in this
book.
Step 2 Press anywhere in the MODE outline. The available icons will
flash. Select THERM . The icon will become solid and the
remaining icons will flash 5 more times before disappearing.
Step 3 Press the arrows to decrease or increase the
set temperature (TEMP).
Step 4 Touch Pad measures the room temperature using a
thermostat inside its case. When the room temperature is
colder than the set temperature (TEMP) the Add-on Cooler will
Turn OFF. The cool symbol and fan symbol will be displayed
on the control to indicate the Add-on Cooler is on.
For continuous fan, meaning the fan runs continuously and the
condenser unit only cycles ON and OFF the display should
show FAN and THERM.
Step 5 The Touch Pad will run the Add-on Cooler until it measures the
room temperature (ROOM) a little below your set temperature
(TEMP) and then turn off the condenser unit until the
temperature rises a little below SET temperature.
The operation of the Add-on Cooler is as follows:
• The Add-on cooler will start almost immediately when first
turned ON. Once the unit has turned OFF when in
operation there is a 5 minute delay before it will resume
again and a minimum of 5 minutes operating time before it
can turn off again.
• The room air fan will always run on high speed. The room air fan can be set as always on
or it can be set to cycle ON and OFF with the Condenser Unit.
• When the temperature has gone under the SET temperature by approximately 1° the
condenser unit will shut down.
• When the temperature has gone over the SET temperature by approximately 1° the addon
cooler condenser unit will restart.
To Next Page
Loading...