1. Turn off the DayMark 9700.
2. Pull down the access door on the right hand side of the screen.
3. Remove the existing Micro SD Card located in the middle port. Use caution as the
SD card port is spring loaded.
4. Copy new system files to Micro SD Card.
5. Install the Micro SD Card gold contacts facing front of the unit. Be sure to insert the SD
Card into the card port and not into the gap between the printer and the port. Inserted
correctly.into the card port, the SD Card will meet a slight spring resistance and need to
be pushed in until locked.
6. Power on the DayMark 9700.
MICRO SD CARD UPDATE INSTRUCTIONS
SD Card Port
WARNING: SHOULD NOT BE EXECUTED WITHOUT HELP FROM DayMark.
50.
4. OPERATING SYSTEM MANAGEMENT
To Next Page
Loading...
Need help?
General