OPTICAL MASTER UNIT MARK I
PRODUCT DESCRIPTION AND USER’S MANUAL
Cobham Wireless – Coverage Date: 4-Jan-18 www.cobham.com/wireless
Document number:A1829300UM Rev. 3.1
Page | 52
4. With the cleaning-head end fully
engaged in the connector, push
until an audible “click” is heard
5. Without fully withdrawing the cleaning
head end push it in again twice more,
each time until an audible “click” is
heard.
6. Withdraw the “One Click” cleaner and
replace the protective end cap.
7. Inspect the fibre connector using a Fibrescope. On the PC monitor, verify that there is no
contamination present on the connector end-face.
8. If the connector is dirty, clean it with a wet cleaning technique followed immediately by dry
cleaning. This is to remove any remaining residue from the wet clean (the following steps
demonstrate a wet cleaning technique).
To Next Page
Loading...
Need help?
General