CODEL
OPS. 141 19
Issue : A
Revision : 1
Date : 14/06/18
Doc i/d : 0118/6
050028
ZERO
HOLD
F.S.
MEAS
by using the UP and DOWN keys. Press ENTER.
20.Set mA Output is the next option accessed. This option may not
need setting as the output calibration will have been set at the
factory - skip this and go to point 22 if preferred. Press ENTER
and set zero appears on the LCD. Press and hold the UP or
DOWN arrow keys to adjust until 0mA reads on the ammeter - see
5.9.3.6 for detail.
21.Press ENTER when the correct value is read. Similarly set span
value for 20 mA.
22.Press ENTER and EXIT is shown. Press ENTER to return to
MODE 5 menu.
23.Use the DOWN arrow key to access CONFIGURE O/P 2 and
repeat points 11 to 21 (above) for output 2 of the signal processor.
24.Use the DOWN arrow key to access the ALARM 1 sub menu.
Press ENTER and Source is shown on the display.
25.Select the averaging stack which is to be the source for the alarm
for output 1. Use the arrow keys to select either seconds, minutes,
hours or days and press ENTER.
26.The menu scrolls down to Units, similarly to above select the units
for the alarm using the arrow keys, press ENTER when selection
has been made.
27.The menu now scrolls down to Level. Select the level required for
alarm 1. Press ENTER and the menu scrolls to EXIT. Press
ENTER and use the down arrow key to move to ALARM 2.
28.Set the parameters for ALARM 2 (output 2) as in points 23 to 26
(above).
29.Use the DOWN arrow key to select the PARAMETERS sub
menu, press ENTER.
30.The first option in this menu is SECURITY. Press ENTER and use
the UP and DOWN arrow keys to adjust each digit in turn from left
to right. Press ENTER when each digit is correctly selected. After
the fourth digit is set the menu will return to SECURITY.
To Next Page
Loading...
Need help?
General
