Technical Manual Page 18 CODEL
OPS.080 Issue : C Rev. : Date : 16/7/08 Doc. i/d : 0080/6 Ref. : 080040
b) Remove the remaining flat washers and nuts from the alignment suds.
c) Remove the four weather cover mounting bolts and spring washers.
d) Remove the sealing ‘O’ ring from the sensor head mount.
e) Pass the sensor head mount through the hole in the front plate of the weather cover as shown
below. Note that the sensor head alignment studs should be in the vertical plane.
Weather cover mounting bolts
Sealing ‘O’ ring