To Next PageTo Next Page
Need help?Do you have a question about the ComAp IG-NTC and is the answer not in the manual?
General| Brand | ComAp |
|---|---|
| Model | IG-NTC |
| Category | Marine Equipment |
| Language | English |
Safety precautions for remote control operations to prevent unintended engine starts.
Describes power management functions for load reserve in kW and kVA.
Explains relative power management for engine life-based optimization using percentage-based load reserve.
Activates outputs to trip unessential load when gen-set goes to island mode.
Details the start and stop conditions for power management based on actual reserve.
Categorizes protections into fix and configurable groups, detailing protection types and their actions.
Lists firmware-based and configurable default protections for generators and buses.
Details the output for controlling the generator circuit breaker closing and opening.
Details outputs for controlling generator circuit breaker (GCB) and neutral circuit breaker (NCB).
Describes outputs for controlling load shedding stages for partial load switching.
Details Horn and Alarm outputs that activate on various alarm conditions.
Details common outputs for BOC, Alarm Only, and History record type alarms.
Explains common outputs for Warning, Shutdown, Slow Stop, Fail Sensor, and Off Load alarms.
Explains common outputs for 1st and 2nd level alarms, indicating active alarm states.
Configures a gen-set to produce a fixed power regardless of others.
Selects source for System Base load value (internal or external).
Sets the requested gen-set power factor when using BASEPF mode.
Selects source for System Power factor value (internal or external).
Selects system load control mode (BASE LOAD or LDSHARING).
Selects system power factor control mode (BASEPF or VSHARING).
Specifies the overload level where protection evaluation starts.
Selects the IDMT curve shape for overload protection reaction time.
Sets minimum gen-set power level in parallel operation.
Configures shortcurrent detection level and delay.
Selects the IDMT curve shape for overcurrent protection reaction time.
Configures generator over/under voltage and voltage delay protections.
Configures generator over/under frequency and frequency delay protections.
Configures frequency delay and generator stability time.
Configures bus measurement error protection and reverse power alarm.
Configures threshold and delay for earth fault current protection.
Configures the delay for earth fault current protection.
Enables or disables the controller's participation in the Power Management System.
Designates a controller as MASTER for priority evaluation in logical groups.
Sets load reserve levels for stopping gen-sets in ABS (kW/kVA) mode.
Selects power management mode (kW, kVA, or %).
Configures delays for system start-up and stop related to power management.
Configures delays for next gen-set start-up and stopping in power management.
Adjusts gen-set priorities for starting and stopping in power management.
Sets required load reserve levels for starting gen-sets in ABS (kW/kVA) mode.
