ComAp IM-NT - Page 188

InteliMains
NT
, SW version 3.0
InteliMains-NT-BTB-3.0-Reference Guide.pdf, ©ComAp – June 2013
188
Range [units]
1 .. 10000 [X/s]
Related FW
3.0
Force value
possible
YES
Description
This setpoint adjusts the rate pre second at which the ExtValue 3 is beeing
changed while the input ExtValue3 up or ExtValue3 down is active.
12.2.11.28 Setpoint: ExtValue4 rate
Group
Force value
Range [units]
1 .. 10000 [X/s]
Related FW
3.0
Force value
possible
YES
Description
This setpoint adjusts the rate pre second at which the ExtValue 4 is beeing
changed while the input ExtValue4 up or ExtValue4 down is active.
12.2.11.29 Setpoint: ExtValue1deflt
Group
Force value
Range [units]
-32000 .. 32000 [x]
Related FW
3.0
Force value
possible
YES
Description
This setpoint adjusts the reset (initial) value of the ExtValue 1. This initial
value is applied either when the controller is powered-on or when the
ExtValue 1 is reset by the binary input ExtValue1reset.
12.2.11.30 Setpoint: ExtValue2deflt
Group
Force value
Range [units]
-32000 .. 32000 [x]
Related FW
3.0
Force value
YES